Save money by restoring old oak furniture instead of buying new pieces.
Part of the beauty of having old oak furniture is being able to refinish damaged finishes and tighten joints to restore the furniture to a visually appealing and useful state. Turning a yard sale find or grandma's hand-me down into an attractive addition to the home is possible with a little work. Old oak furniture offers desirable wood grains and generally good furniture craftsmanship. Refurbishing old oak furniture is less expensive than buying new furniture, making restoration a wise decision. Does this Spark an idea?
Instructions
1. Set the old oak furniture in the workspace. Remove all hardware including drawer pulls, knobs and decorations.
2. Equip an orbital palm sander or sanding block with 120-grit sandpaper and sand the old finish off the furniture. Sand legs, spindles and other rounded pieces or curves by hand. Turn the furniture over to sand the underside.
3. Wipe all of the furniture surfaces with a tack cloth to remove the dust and debris. Vacuum the dust and debris from the work area with a shop vacuum.
4. Equip the palm sander or sanding block with 220-grit sandpaper and sand all of the surfaces of the furniture a second time, following the direction of the wood grain. Wipe the furniture with a tack cloth and vacuum the work area with a shop vacuum. Sand the furniture in the direction of the wood grain a third time with 320-grit sandpaper using a palm sander or sanding block. Wipe the furniture with a tack cloth and vacuum the work area again.
5. Examine all of the furniture joints to determine if they are loose or wobbly. If a joint is loose, add wood glue and clamp the joint to hold it firmly in place. If the joint is dangerously loose, remove the joint, sand off the old adhesive, apply wood glue, put the joint back in place and clamp it with a hand-screw-clamp. Let the wood glue dry for four to six hours.
6. Check the surface for scratches, deep gouges or chips. Fill in damaged areas with wood filler. Let the wood filler dry for two to three hours. Sand the wood with 320-grit sandpaper to make the repair flush with the existing surface. Wipe the surface with a tack cloth.
7. Dip a small section of a clean, lint-free rag into a gel wood stain, if you desire a color other than natural oak. Wipe off excess stain on the edge of the stain can. Place the rag on the edge of the furniture and wipe the stain onto the surface in one smooth motion, following the wood grain from one side to the other side of the furniture. Do not move the staining rag back and forth over the area; only move in one direction. Continue to dip the rag into the stain, remove excess stain and wipe the stain across the furniture until stain covers all surfaces. Let the stain dry for three to four hours. Turn the furniture over and stain parts of the furniture that were out of sight using the same method as you did for the rest of the piece.
8. Continue to add layers of stain until you reach your desired depth of color. Let the final coat of stain dry overnight.
9. Sand the oak furniture surface lightly with 400-grit sandpaper, following the wood grain. Wipe the surface with a tack cloth.
10. Dip a foam applicator into polyurethane and apply two to three coats, allowing each coat to dry for three to four hours.
Tags: tack cloth, with tack, with tack cloth, wood grain, four hours