An elegant table is the centerpiece of any dining room. But elegant doesn't have to mean expensive. With the right materials and a little know how, elegance can be achieved on a shoestring budget. Does this Spark an idea?
Instructions
1. Buy the 2x4s and 2x12s. If you don't have a truck have each piece cut in half at the Home Improvement Store.
2. Make Cuts. 2x4s: 8@ 28 1/2 inches. 2@59 7/8 inches. 2@ 31 inches. 1@33 1/2 inches.
2x12s: 4@ 71 7/8 inches.
3. Screw two 28 1/2 inch 2x4s together making sure they line up evenly at both ends (flush) and on all edges. You'll make a total of four of these pairs. These are your legs. Notice that they do not make a square. Instead they are 3 inches x 3 1/4 inches.
4. Screw each end of each 59 7/8 2x4 into the 3 inch side of each leg. Make sure you are flush with the top and the outside edge of the legs. This creates the long edge of your table. Screw each 31 inch 2x4 into each 3 1/4 inch of each leg making the short edge of your table. Finish the lower frame off by centering the 33 1/2inch 2x4 and attaching it to the long edges.
5. Center the 2x12s over the top of the table frame you just built. Make sure there is even space on both ends (3 inches) and on both sides (also 3 inches). Screw the 2 x 12s into the legs and rails of the table frame.
6. Fill in all the screw holes with wood filler. Let it dry. Sand the entire table.
7. Brush on Stain. Wipe off excess. For a deeper color add another coat.
8. Brush or spray on a coat of laquer. After it dries, sand it lightly with 220 grit sandpaper. Repeat 2 or 3 times.
9. Show off your table to all your friends.
Tags: inches Screw, your table, both ends, each inch, edge your, edge your table